![]() In this case, the QNAP is controlling the drives, not macOS. Keep Drive Spinning for Mac OS X 3.0 full screenshot - offers free software downloads for Windows, Mac, iOS and Android computers and. You need to go into QTS and set the appropriate settings to disable Standby mode. #Keep drive spinning for mac for mac os x# For the firmware, the user guide says that there is a default Standby Mode: The device can be run via firmware, in which case here are DIP switches to control the RAID mode, or via a Mac App (QNAP External RAID Manager). When install Keep Drive Spinning on the Mac, it will also bring many of its supported files to the Mac, including application support files, preferences, caches etc. Unless your G Drive has firmware that causes it to spin down after a period of inactivity, it should respond to the settings in the Energy Saver system preference of the OS. *"The RAID enclosure features standby mode to help reduce noise and power consumption. The issue is that sometimes it breaks some things you had open or on the side. It then takes a while to start spinning again. ![]() Thank you for reaching out, and I do apologize for any issues you may be having. Do you have an external mechcanical drive Chances are, when you stop using it, it stops spinning. Go to the Apple menu, select System Preferences and open your Energy Saver preference. Our G-Technology G-Drive USB-C is a spinning hard disk. It sounds as though it's always spinning - even on idle. Make sure you dont have Put hard disks to sleep when possible checked. It's more noticeable now since I've been using on ear headphones that don't isolate background noise well. When the RAID enclosure enters standby mode, the system fan and installed HDDs stop spinning, and system processes are I've tried all the basic fixes such as disabling automatic defrag, disabling windows defender, and disabling anything else that may cause my hard drive to spin on idle, all to no avail. Upon waking, the RAID enclosure returns to the previous system state and any paused processes are resumed. You can stop the spinning wheel and get back to a smooth Mac experience using one of these fixes. The RAID enclosure enters standby mode under the following conditions: Mac OS include an Energy Saver feature that can cause hard drives connected in or to the computer to spin down after a period of inactivity. Determine whether the spinning wheel of death is the result of a single app by force quitting it. Restart it again, and there may be no problem. Every ten seconds or so, the HDD spins up, then down, seemingly endlessly (long enough to make me want to leave the room at least). ![]() If you see the spinning pinwheel again with that app, it could be a culprit. The HDD in question is a Hitachi Deskstar 500GB 7200RPM SATA, running in my recently built pfSense (FreeBSD) box (Athlon 64 X2, 2GB RAM, 2.3.2-RELEASE-p1 latest). The host enters hibernation or standby mode or is powered off. ![]() The RAID enclosure only enters standby mode if the USB power design of the host supports this feature. Perhaps there has been some other change that changes the way the QNAP 'sees' the Mac USB port? You might try the RAID Manager, see if that gives you additional options.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |